ESP8266 WiFi module

Recently I received some really cheap WiFi modules.

The Wi07C isn’t much more than a little rectangular board with a WiFi chip, flash chip, and copper trace antenna.



The little board on the left is the ESP8266 board. It’s wired to a CP2102 UART to USB bridge and powered by a 5V – 3.3V buck converter I had laying around.

I bought the ESP8266 board from a store in Korea called Electrodragon

Pinout and AT command reference here

I made 5 connections for this demonstration:
VDD to +3.3v
RX to TX on CP2102
TX to RX on CP2102
RST to +3.3v

On my computer I ran a perl script that listens for connections on port 8001 and simply spits out data that it receives. If it receives the text “PING?” then it responds with “OK”

So I connected to the CP2102 UART bridge using Realterm. The baud rate is 57,600. The line endings are CR but CR+LF will work fine.

I sent the following commands to the module to

1. Connect to my WiFi AP
2. Establish a TCP/IP connection
3. Send data
4. Disconnect


Here’s a screen shot of what was echoed back to me on Realterm:


So I actually sent the PING twice. The last character after PING doesn’t matter in my perl script. You can see the second time I sent 7 characters. PING is 4. There’s a space you can’t see, and then CR+LF for a total of 7. The +IPD,3:OK indicates that the host (the perl script) returned 3 characters: “OK” and then a CR character.

I’m impressed that a $4.50 WiFi module does anything at all, but it actually worked without much trouble so I’m very impressed.

I then ran a command that the module didn’t like, and it’s only responding with “busy now …” to any command I send it. I’ll have to toggle the RST line or power in order to reset the device. An acceptable caveat or will this prove to be a persistent problem?

Here’s the perl script I used:



use IO::Socket::INET;

# auto-flush on socket
$| = 1;

# creating a listening socket
my $socket = new IO::Socket::INET (
LocalHost => '',
LocalPort => '8001',
Proto => 'tcp',
Listen => 5,
Reuse => 1
die "cannot create socket $!\n" unless $socket;
print "server waiting for client connection on port 8001\n";

# waiting for a new client connection
my $client_socket = $socket->accept();

# get information about a newly connected client
my $client_address = $client_socket->peerhost();
my $client_port = $client_socket->peerport();
print "connection from $client_address:$client_port\n";

# read up to 1024 characters from the connected client
my $data = "";
$client_socket->recv($data, 1024);
print "received data: $data\n";

print $data;
# write response data to the connected client

# read up to 1024 characters from the connected client
my $data = "";
$client_socket->recv($data, 1024);
print "received data: $data\n";

if($data =~ m/PING.*/){
$data = "OK\n";
} else {
goto shdn;
# write response data to the connected client
print $data;

# close
shutdown($client_socket, 1);